This is a modification of my WEB filter that helps you create lines and sheets of connective blocks in MCEdit. LINES v3 allows the new sheets to be in a specific block type, not just determined by the end points.   Say you have a couple of different wall sections and a gap between. This filter simplifies filling in the blocks between the two. Take the following example. Here is a dome with a regular wall section beneath it. There is a gap between. To fill in the gap would take a long time and will be very irregular. Instead, create a selection box with the blocks above and below all within it. Then simply run the LINES filter attached below.     |
MCEdit Filters >
